Pope DC Series Amplifier Description The POPE Professional® DC-1000 amplifier is designed for commercial and industrial sound reinforcement. All the controls are in the front panel for easy access. The DC Series amplifier can drive 4-16 ohm or constant voltage loudspeakers. Features : This Amplifier can use in meeting rooms, classrooms/schools, houses of worship, courtrooms, multi zone paging/music, theme parks, museums, office and conference rooms. • 6 Mic, 2 Aux and L, R Inputs • Short circuit, over-current, over-heat, and overload protection • Multifunctional device • 48V phantom power for 6 mics and 1, 2 mic priority • Provide 4-16 ohm and constant-voltage output (70V and 100V) • L, R mix outputs • Parallel, Stereo and Bridge selection Application Specifications Ratings (RMS @ 1% THD @ 230VAC) Model DC-1000 Article No. #10017 Number of channels 2 Total output all channels driven 1000 W @ 4 ohms Max. Output Power 4 ohms 8 ohms 70 V 100 V Stereo Mode (per channel watts) 500 W 250 W 500 W 500 W Bridge Mode 1000 W THD+N (typical) < 0.05 % (20 Hz - 20 kHz, 8 Ω load, 3 dB below rated power) Signal To Noise-Ratio > 120 dB (A-weighted, 20 Hz - 20 kHz, 8 Ω load) Frequency Response 20 Hz - 20 kHz ± 0.25 dB / 20 Hz - 20 kHz ± 0.15 dB (8 Ω load, 1 dB below rated power) Output Circuitry Class D - full bandwith PWM modulator with ultra low distortion Input impedance 15 kΩ balanced Damping Factor > 2000 (8 Ω load, 1 kHz and below) Gain and Level Amplifier gain selectable (Sensitivity) 0.7 / 1.0 / 1.44 Volt Level adjustment (per ch.) Front-panel potentiometer Connectors and Switches Input connectors (per ch.) Neutrik® 3-pin XLR electronically balanced for L & R, Neutrik® 3-pin XLR & TRS Combo for 6 mic, Female RCA for Aux 1, 2 Output connectors (per ch) Neutrik® 3-pin XLR, electronically balanced and Neutrik® 4 Pin Speakon Power on/off on front-panel switch Cooling One fan, front-to-rear airflow Front-panel indicators Per channel Power / Signal / Limit / Protect / Parallel / Bridge / 6 mic / 2 Aux Parallel 1 & 2 Channels